Gate control panel with Adjustment and programming by trimmer and dip-switch.
V2 Flexy control panel great as a replacement controller for gates requiring an analogue panel . 2 remote controls also included to match controller.
230V power supply for 2 single-phase motors
Built-in receiver (433,92 MHz) Possibility to store up to 240 Personal Pass transmitter RJ45 connector to connect the control unit to the programmer PROG2 via standard network cable (UTP)
Start, pedestrian start and stop controls from transmitter Open/close limit switch inputs
230V flashing light output (use flashing lights with intermittence)
Courtesy light output (also controllable by transmitter) Safety device test before any opening Leaf slow-down function in limit switch area to prevent noisy closures and rebounds
Monitoring of input status shown by LEDs
Note force adjustment available with adjustable pots but no encoder detection or force reversal built in.
Suitable for most gates if in doubt please check.
Necessary cookies are absolutely essential for the website to function properly. This category only includes cookies that ensures basic functionalities and security features of the website. These cookies do not store any personal information.
Any cookies that may not be particularly necessary for the website to function and is used specifically to collect user personal data via analytics, ads, other embedded contents are termed as non-necessary cookies. It is mandatory to procure user consent prior to running these cookies on your website.